Cord Assembly; How To Start - Kenmore 116.32712 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

Using a
screw-
driver,
tighten
the
screw.
m
. CAuTmoN
Do not overtlghten.
Overttghtenlng could strip the
screw holes.
Do not operate the cleaner without
the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position, Remove
the wire tfe from the power cord,
Lock the cord
into place by
forcing it into the
locking notch on
lhe body of the
quick release
upper cord hook
as shown, This
helps keep the
power cord out
from under the
vacuum cleaner
agitator.
Lockin[
Notch
Wrap the power cord around tile upper
and lower cord hooks and lock the power
cord plug onto the power cord,
Power
Cord
Lower
Cord
Hooks
HOW TO START
Qttlck Releat
pper Cord
1. Turn the
quick
release
upper cord
hook to
either side
and down to
release the
power cord
2. Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook., Check to be
sure the power cord is still locked inlo the
lock in the quick release upper cord hook,,
3. Check to see if the cleaner has bag
installed_ See DUST BAG CHANGING
NOTE: To reduce the risk of electric
shock, this vacuum cleaner has a polar-
ized plug, one blade is wider than the
other°This plug will fit in a polarized outlet
only one way. If the plug does not fit fully
in the outlet, reverse the plug., If it still
does not fit, contact a qualified technician
to install the proper outlet. Do not change
the plug in any way_
4. Plug the polarized power cord into a
120 Volt outlet located near the floor,
.............
Personal Injury and Product Damage
Hazard
* DO NOT plug in if switch is in the ON
position.Personal Injury or damage
could result.
, DO NOT use outlets above counters.
Damage to items In surroundingarea
couldoccur.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents