Cord Assembly; How To Start - Kenmore 11632729 Owner's Manual

Using a
screw-
driver,
tighten
the
screw,
CAUTION
Do not overtighten.
Overtightening could strip the screw
holes.
Do not operate the cleaner without
the screw in place.
CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove the
wire tie from the power cord,,
Lock the cord into \
place by forcing it
into the locking
notch on the body of Locking
Notch,
the quick release
upper cord hook as
shown. This helps
keep the power cord
out from under the
Power
vacuum cleaner agi- Cord
tator.
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord.
Quick Release
Upper Cord
Hook
Power
Cord
Lower
Cord
Hooks
If
HOW TO START
Release
Cord
Turn the quick
release upper
cord hook to
either side
and down to
release the
power cord..
Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hooL Check to be sure
the power cord is still locked into the lock in
the quick release upper cord hook.
Note: To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the other.
................ ::_i;
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install the
proper outleL Do not change the plug in any
way°
Plug the polarized power cord into a 120
Volt outlet located near the floor.
WARNING ...........
Personal Injury and Product Damage
Hazard
• DO NOT plug in if switch is in the
ON position. Personal injury or dam-
age could result.
, DO NOT use outlets above coun-
ters. Damage from cord to items in
surrounding area could occur.