On/Off Switch - Kenmore 116.32712 Owner's Manual

Release the handle by pressing down on
the handle release pedal with your foot
and pulting back and down on the handle
with your hand..
HANDLE MOUNTED
SOME MODELS
To start the vacuum cleaner, slide the
OnlOff switch from the OFF position lo
the ON position. To stop the vacuum
cleaner, slide the On/Off switch to the
OFF position..
Crevice
Tool
Telescoping,
Dusting
Hose
Combfnetion
Brush _ Hose
_1(_ Collar
Identifyeach of the attachments shown
above.
TO USE ATTACHMENTS
Place the carpet/bare floor selector in the
bare floor settingby rotating the selector
back and down to the bare floor setting.
See CARPET/BARE FLOOR SELECTOR
section.
When returning the bare floor selector to
the carpet setting, use caution as the
selector can move quickly to that setting
due to tension created by the bell
Remove the lower end of the stretch hose
from the cleaner by grasping the hose
collar, twistingand pulling straight out.,
The attachments can now be added to
the hose..
NOTE: The motor protector may open
when using attachments or when cleaning
new carpet, due to reduced airflow by the
attachments themselves or by new carpet
fuzz filling the bag quickly. See the
TROUBLESHOOTING section°
. wARN NG .....
Electrical Shock And Personal
Injury Hazard
Disconnect electrical supply before
servlclng or cleaning the unit.
Failure to do so could result in
electrical shock or personal injury
from cleaner suddenly starting,