Installation; In-Band Access - Edge-Core ES4324 Installation Manual

A
Troubleshooting

Installation

Verify that all system components have been properly installed. If one or more
components appear to be malfunctioning (such as the power cord or network
cabling), test them in an alternate environment where you are sure that all the other
components are functioning properly.

In-Band Access

You can access the management agent in the switch from anywhere within the
attached network using a Web browser, or other network management software
tools. However, you must first configure the switch with a valid IP address, subnet
mask, and default gateway. If you have trouble establishing a link to the
management agent, check to see if you have a valid network connection. Then
verify that you entered the correct IP address. Also, be sure the port through which
you are connecting to the switch has not been disabled. If it has not been disabled,
then check the network cabling that runs between your remote location and the
switch.
A-2