Solving Problems; Error Messages - Epson LabelWorks Cable and Wire Kit User Manual

Solving Problems

If you have a problem with your LabelWorks,
check the display or the troubleshooting
suggestions below.

Error messages

Insert tape Turn the power off and install a
tape cartridge.
Check tape! An incompatible tape cartridge
has been installed. Check the tape
Check tape
cartridge.
cartridge
Check battery The batteries may be running out
or installed incorrectly, non-
alkaline batteries are being used
with alkaline batteries, or old and
new batteries are being used
together. Turn the power off and
replace batteries with new ones,
or use the optional AC adapter.
Make sure new batteries are
installed correctly.
Too many lines You have exceeded the maximum
number of lines (4). Press
delete the lines indicated.
Seq. num. only 1
Text too long
Text is too long.
Continue?
Text will be
deleted. OK?
Fill every digit
Load wider tape
Overheated!
to
Sequence numbers have already
been set. You can only enter one
sequence number per label.
Entered text is too long for the
specified label length. Press
and adjust the label length or
make text shorter.
Entered text is too long for the
specified label length. Press
to confirm and continue printing.
The label length will be adjusted
automatically.
When creating labels with a
special format, the current text
will be deleted. Press
delete the text and show the
special format.
Entered values for barcodes are
incorrect. Make sure the barcode
format is supported and that the
correct number of values is
entered.
Unable to print on the current
tape. Use a wider tape.
The print head is too hot. Turn the
power off and take out the tape
cartridge. Allow the print head to
cool before trying to print again.
Solving Problems
to
| 27