Epson LabelWorks Cable and Wire Kit User Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Printer
  5. LabelWorks Cable and Wire Kit
  6. User manual
Epson LabelWorks Cable and Wire Kit User Manual

Epson LabelWorks Cable and Wire Kit User Manual

Document
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
User's Guide

Advertisement

Table of Contents
loading

Related Manuals for Epson LabelWorks Cable and Wire Kit

Summary of Contents for Epson LabelWorks Cable and Wire Kit

  • Page 1 User’s Guide...

  • Page 2: Table Of Contents

    Contents Welcome Customizing Your Labels ........3 .
  • Page 3 FCC Compliance Statement....35 Epson America, Inc. Limited Warranty ..36 Trademarks ......38...

  • Page 4: Welcome

    Welcome With the tapes listed on the back cover, you can do even more: Your LabelWorks Cable and Wire Label Kit ■ Organize stuff in your kitchen, bathroom, lets you create custom labels to help you and every room of your house identify your cables, wiring, and other cords.

  • Page 5: Getting Started

    Getting Started 2. Insert 6 AA alkaline batteries, positioning the + and - ends as shown. Your LabelWorks printer requires 6 AA batteries (not included). An optional AC adapter is also available (C52CB73020). Follow the instructions in this section to insert the batteries and tape cartridge.

  • Page 6: Using The Optional Ac Adapter

    Using the optional AC adapter Inserting a label cartridge Plug in the AC adapter as shown. 1. Remove any slack from the label. Remove the rear cover. Caution: Make sure you use only the AC adapter designed for your LabelWorks printer (C52CB73020) or damage may occur.

  • Page 7: Removing A Label Cartridge

    3. Insert the cartridge and press it down Removing a label cartridge firmly until it snaps into place. 1. Remove the rear cover. 2. Hold the cartridge by the tabs, and lift it straight up. 4. If there is excess label, feed the end through the tape guide slot.

  • Page 8: Creating Labels

    Creating Labels Creating long labels The number of characters and symbols you Enter text to begin creating your label. Then can enter is limited, but you can use the follow the suggestions for adding length if following techniques to create longer labels: necessary.

  • Page 9: Saving Labels

    Saving Labels Enhancing Your Labels You can store up to 50 saved labels at a time. Get creative by adding symbols or frames to your labels and selecting the right font for After you finish creating your first label, press each label.
  • Page 10 Symbols Prohibition Household Food Sports Activity Enhancing Your Labels...
  • Page 11 Occasion Shipping Electrical Animals Zodiac Emoticons Enhancing Your Labels...
  • Page 12 Measurement Metric Abbreviation Punctuation Parentheses Math Enhancing Your Labels...
  • Page 13 Currency DoubleFigure Greek Office Safety Facility Enhancing Your Labels...

  • Page 14: Adding Frames

    Adding frames Frames include borders and symbols for activities and other purposes. 1. Press 2. Press to scroll through the frames or enter the frame number to jump directly to a frame, then press to select the frame you want to use. Note: To quickly remove a frame from a label, press type the number “0”, then press twice.
  • Page 15 Enhancing Your Labels...

  • Page 16: Changing The Font Size

    Changing the font size Changing the font You can change the size of the letters, Choose a font that fits your needs. numbers, and symbols on your label. 1. Press 1. Press 2. Press to scroll through the fonts, then 2.

  • Page 17: Changing The Font Style

    Printing Labels Changing the font style Personalize your label text with bold, italic, 1. Press to print the current label. shadow, and outline effects. The length of the label and the number 1. Press of copies shows on the display while the 2.

  • Page 18: Printing Multiple Copies

    Customizing Your Labels Printing multiple copies You can print up to 9 copies of a label on one You can customize your labels by creating label. This lets you create longer labels for special effects, such as vertical and mirrored panels with multiple input/outputs or other text.

  • Page 19: Adding Space Between Characters

    Adding space between characters Increasing print density You can add extra space between the letters, You can make the print on your labels darker numbers, and symbols on your label. if necessary. 1. When the power is off, press Print density appears on the display. 2.

  • Page 20: Adding Letters With An Accent Mark

    ■ Press repeatedly to scroll through the Customizing the length of labels first group of marks, then press You can specify the length of your labels (up select the desired mark. to 15 in.) ■ Press , then press repeatedly 1.

  • Page 21: Creating Sequentially Numbered Labels

    Cable and Wire 1. Press 2. Press until you see Mirror print, then Management press to select it. You can use custom labels to identify cords 3. Press to select On, then press and cables. Because cables can flex and stretch, we recommend labels with strong Creating sequentially numbered adhesive.

  • Page 22: Flag Labels

    Flag labels Flag label tips ■ When labeling cables with a flag label, Flag labels provide a large surface for set a specific length for the label. If you multiple lines of text. A vertical line marks use the “Auto” feature, the text will be too the center of the flag to help wrap the cable close to the center of the label and you evenly.

  • Page 23: Wrapped Labels

    Wrapped labels Wrap label tips ■ For small cables (1-2 mm), use a flag label Wrapped labels are useful for tight spaces to increase readability. where flags are too large or only a short identifier is necessary. ■ If you only have a single line of text, repeat it on multiple lines to improve readability.

  • Page 24: Asset Management

    Asset Management Barcode labels LabelWorks can create barcode labels in a Use labels to organize and track inventory, variety of formats. These barcodes can be equipment, and other assets. used for inventory management and asset tagging. Organizing with labels Supported formats: CODE39, CODE128, ITF, LabelWorks labels can be used in many CODABAR, UPC-A, UPC-E, EAN-8, EAN-13 different ways to improve the organization...

  • Page 25: Index Tab Labels

    The following barcode settings can be Index tab labels modified: You can print index tab labels for labeling folders and dividers. Width: Adjusts the space between the bars of the barcode. Note: Index tabs are only available when printing on 1/2” (12 mm) or 3/4” (18 mm) tape. Ratio: Adjusts the width of the wide bars in the barcode (2, 2.5, or 3 thin bar widths).

  • Page 26: Adjusting The Display

    Adjusting the Display Cleaning the Printer You can adjust the following display settings: Use a dry, soft cloth or, for stubborn stains, a moist cloth that has been wrung dry. Backlight: Turns the backlight of the display on or off. Caution: Never use chemicals or solvents such as benzine, thinner, alcohol, or a chemical Contrast: Adjusts the density of the fonts on...

  • Page 27: Storing Your Kit

    Storing Your Kit LabelWorks LW-400 Two LabelWorks cartridges LabelWorks Six AA batteries AC adapter (optional) (available separately) Storing Your Kit...

  • Page 28: Solving Problems

    Solving Problems Seq. num. only 1 Sequence numbers have already been set. You can only enter one sequence number per label. If you have a problem with your LabelWorks, Text too long Entered text is too long for the check the display or the troubleshooting specified label length.

  • Page 29: Problems And Solutions

    If the same cancel, press any other button). message appears, turn the power off again and contact Epson for The product will be reset. technical support. Power is on but no images appear on the...
  • Page 30 ■ ■ If you are using the AC adapter, make Make sure the rear cover is closed. sure that it is securely connected to both Characters do not print properly the wall outlet and the product. ■ Make sure the tape cartridge is correctly ■...

  • Page 31: Epson Technical Support

    Days and hours of support are subject to change without notice. Toll or long distance charges may apply. Recycling Epson offers a recycling program for end of life products. Please go to www.epson.com/ recycle for information on how to return your products for proper disposal.

  • Page 32: Purchase Supplies And Accessories

    Registration Purchase supplies and accessories Epson offers a wide array of tapes for To receive special offers and updates on new multiple uses. For a complete list of available tapes, make sure you register your tapes, including additional widths, visit LabelWorks printer.

  • Page 33: Specifications

    ■ Power supply - Model: C52CB73020 Do not spill liquid on the product or use the optional AC Manufacturer: Seiko Epson Corp. product with wet hands. adapter Input: AC100-240 V, 0.3 A, 50-60Hz ■ Do not open any covers on the product other than Output: DC 6.5 V, 1.5 A...
  • Page 34 ■ Continuing to use the product may result in Operate the keyboard gently. damage or injury. ■ Take care not to cut your fingers when cutting a ■ To avoid injury, keep your fingers away from the tape with scissors. label exit slot when printing or using the cutter.

  • Page 35: Tape Cartridges

    ■ ■ Remove dead batteries promptly. Place the AC adapter and power cord to avoid abrasions, cuts, fraying, crimping, and kinking. Do ■ Do not heat batteries or throw them in fire or not place heavy objects on top of the AC adapter or water.

  • Page 36: About Printed Labels

    ■ Connect the equipment into an outlet on a circuit Epson is not responsible for any damage or loss caused different from that to which the receiver is by labels or adhesive. connected. ■...

  • Page 37: Epson America, Inc. Limited Warranty

    Epson property. The replacement your Epson product prove defective during the product or part may be new or refurbished to the Epson warranty period, please call the Epson Connection standard of quality, and, at Epson’s option, may be (562) 276-7245 (U.S.
  • Page 38 Epson is not responsible for warranty OR CONSEQUENTIAL DAMAGES RESULTING FROM THE service should the Epson label or logo or the rating label USE OR INABILITY TO USE THE EPSON PRODUCT, or serial number be removed or should the product fail...

  • Page 39: Trademarks

    This warranty gives you specific legal rights and you may have other rights which vary from jurisdiction to jurisdiction. To find the Epson Authorized Reseller nearest you, visit our website at http://www.epson.com. To find the Epson Customer Care Center nearest you, visit http://www.epson.com/support.
  • Page 40 Display Turn on/off Print Repeat design Add symbols Add a special effect Delete Shift Select/Enter Caps lock Add an accented letter Add a space...
  • Page 41 Font size Frame Design number Line number The black marks Battery level indicate features you are using...
  • Page 42 LabelWorks tapes available at www.epson.com/LabelWorks 1/4 inch 3/8 inch 1/2 inch 3/4 inch (6 mm) (9 mm) (12 mm) (18 mm) LC-4WBW9 LC-4YBW9 LC-5WBW9 LC-5YBW9 Strong Adhesive LC-5RBW9 LC-4BWV9 LC-5BKP9 LC-5WBN9 LC-4WBN9 Standard LC-5SBE9 labels LC-4NWT5 LC-5TWN9 LC-5TBN9 LC-5TKN9 LC-5SBM9...

Table of Contents