Clearing Forgotten Passwords; Changing Boot Sequence For Future Boots - Dell Inspiron 518 Service Manual

USB device such as a USB floppy drive, or a memory key.
1. If you are booting to a USB device, connect the USB device to a USB connector.
2. Turn on (or restart) your computer.
3. When F2 = Setup, F12 = Boot Menu appears in the upper-right corner of the screen, press <F12>.
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft Windows desktop. Then shut down your
computer and try again.
The Boot Device Menu appears, listing all available boot devices. Each device has a number next to it.
4. On the Boot Device Menu choose the device you want to boot from.
For example, if you are booting to a USB memory key, highlight USB Flash Device and press <Enter>.
NOTE: To boot to a USB device, the device must be bootable. To ensure your device is bootable, check the device documentation.

Changing Boot Sequence for Future Boots

1. Enter system setup (see Entering System
2. Use the arrow keys to highlight the Boot Device Configuration menu option and press <Enter> to access the menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3. Press the up- and down-arrow keys to move through the list of devices.
4. Press plus (+) or minus (–) to change the boot priority of device.
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located that shipped with your computer.
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Locate the 3-pin password connector (CLEAR_PW) on the system board (see
Inspiron™ 518
Inspiron 519
Setup).
Begin.
Removing the Computer Cover).
System Board Components).