Dell Inspiron 518 Service Manual page 19

3. Disconnect the processor fan cable from the CPU_FAN connector on the system board (see
4. Carefully move away any cables that are routed over the processor fan and heat sink assembly.
5. Follow the instructions below to replace the processory fan and heat sink assembly, depending on your computer model:
Inspiron 518
a. Loosen the four captive screws securing the processor fan and heat sink assembly and lift it straight up.
1 processor fan and heat sink assembly 2 captive screws (4)
NOTE: The processor fan and heat sink assembly in your computer may not look exactly like the one shown in the illustration above.
b. To reinstall the processor fan and heat sink assembly, align the captive screws on the processor fan and heat sink assembly to the four metal
screw hole projections on the system board.
c. Tighten the four captive screws.
Inspiron 519
a. Rotate the clamp lever 180 degrees counter-clockwise to release the clamp grip from the bracket projection.
b. Release the clamp grip from the bracket projection on the opposite side.
c. Rotate the heat sink assembly upward gently, and remove it from the computer. Lay the heat sink assembly down on its top, with the thermal
grease facing upward.
1 clamp lever 2 bracket projection 3 clamp grip
4 bracket 5 heat sink
7 fan
d. Place the heat sink and fan assembly back onto the heat-sink assembly bracket.
e. Ensure that the two clamp grips are aligned with the two bracket projections.
6 fan cover
System Board Components).