Table of Contents
Advertisement
About this task
The following image indicates the location of the CMOS jumper-pins and provides a visual representation of the removal
procedure.
Steps
1. Remove the jumper plug from the password jumper-pins and connect it to the CMOS jumper-pins.
2. Wait for 5 seconds and then replace the jumper plug in its original location.
Next steps
1. Install the
system-board
2. Install the stand.
3. Install the
bottom
cover.
4. Install the
back
cover.
Clearing forgotten passwords
Prerequisites
1. Follow the procedure in
2. Remove the
back
cover.
3. Remove the
bottom
cover.
4. Remove the stand.
5. Remove the
system-board
About this task
The following image indicates the location of the password jumper-pins and provides a visual representation of the removal
procedure.
shield.
Before working inside your
shield.
computer.
System setup
67
Advertisement
Table of Contents
