Removing The Camera Module; Replacing The Camera Module - Dell Studio 1450 Service Manual

Back to Contents Page
Camera Module
Removing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
Removing the Camera Module
1. Follow the instructions in Before You
2. Remove the system board (see
3. Remove the WWAN module (see
4. Remove the display assembly (see
5. Remove the display bezel (see
6. Remove the display panel (see
7. Disconnect the camera module cable from the camera module cable connector.
8. Remove the two screws securing the camera module to the display cover.
1 screws (2)
3 camera module cable connector
9. Lift the camera module off the display cover.
Replacing the Camera Module
1. Follow the instructions in Before You
2. Align the camera module over the screw holes on the display cover.
Begin.
Removing the System Board).
Removing the WWAN Module).
Removing the Display Assembly).
Removing the Display Bezel).
Removing the Display Panel).
2 camera module
Begin.
Removing the Battery) before working inside the