Removing The Camera; Replacing The Camera - Dell Studio 1745 Service Manual

Back to Contents Page
Camera
Dell Studio™ 1745/1747 Service Manual
Removing the Camera
Replacing the Camera
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Camera
1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Remove the base cover (see
4. Disconnect the antenna cables from the Mini-Card(s) (see
5. Disconnect the subwoofer assembly cable from the subwoofer assembly cable connector on the system board (see
6. Remove the center control cover (see
7. Remove the keyboard (see
8. Remove the media controls board (see
9. Remove the display assembly (see
10. Remove the display panel (see
11. Remove the two screws that secure the camera module to the display cover.
12. Remove the camera module.
1 screws (2)
3 camera cable connector
Replacing the Camera
Begin.
Battery).
Removing the Base Cover).
Removing the
Removing the Center Control
Removing the Keyboard).
Removing the Media Controls
Removing the Display Assembly).
Removing the Display Panel).
2 camera
Removing the
Mini-Card).
Cover).
Board).
Battery) before working inside the
Removing the Palm Rest).