Dell Studio 1745 Service Manual page 53

Back to Contents Page
Subwoofer Assembly
Dell Studio™ 1745/1747 Service Manual
Removing the Subwoofer Assembly
Replacing the Subwoofer Assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Subwoofer Assembly
1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Follow the instructions from
4. Loosen the three captive screws that secure the subwoofer assembly to the computer base.
5. Lift the subwoofer assembly out of the computer base.
1 captive screws (3)
Replacing the Subwoofer Assembly
1. Follow the procedures in Before You
2. Place the subwoofer assembly on the computer base.
3. Tighten the three captive screws that secure the subwoofer assembly to the computer base.
4. Follow the instructions from
5. Replace the battery (see Replacing the
Back to Contents Page
Begin.
Battery).
step 2 to step 19 in Removing the System
2 subwoofer assembly
Begin.
step 6 to step 21 in Replacing the System
Battery).
Removing the
Board.
Board.
Battery) before working inside the