Table of Contents
Advertisement
Step by Step
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
code:
86/#86 (Æ page 26)
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code:
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition:
Precondition: You have a telephone that uses tone dialing (DTMF di-
Precondition:
Precondition:
aling) or you can switch your telephone to tone dialing. The tele-
phone is not connected to the system.
Set up a call to the system. Enter the station number (contact System
Support).
Wait for a continuous tone (if necessary switch the telephone to tone
dialing), then enter the internal number that has been assigned to you
and the associated PIN.
Enter the code (necessary only if programmed in the system).
Wait for a dial tone and then enter the code, such as
disturb on. Make other inputs as necessary; (refer to the operating in-
structions for pulse and DTMF telephones).
or or or or
Dial the external number.
You can only execute one function at a time, or set up only
one outgoing connection.
The connection is immediately released after successful ac-
tivation of a function.
In the case of an external-external call, the connection is re-
leased as soon as either of the parties ends the call.
Using Other Functions
81/#81 (Æ page 80)
*
85/#85 (Æ page 80)
*
87/#87 (Æ page 15)
*
61 (Æ page 21)
*
89/#89 (Æ page 22)
*
90/#90 (Æ page 71)
*
97/#97 (Æ page 19)
*
98/#98 (Æ page 19)
*
7 (Æ page 41)
*
83 (Æ page 67)
*
97 for Do not
*
69
Advertisement
Table of Contents
