Replacing The Camera Module - Dell Inspiron 1090 Service Manual

12. Make note of the camera cable routing and disconnect it from the connector on the camera module.
13. Lift the camera module off the display frame.
1 camera cable
Replacing the Camera Module
1. Follow the instructions in Before You
2. Use the alignment posts on the display frame to place the camera module in position.
3. Route and connect the camera cable to the connector on the camera module.
4. Replace the display panel (see
5. Replace the display hinges (see
6. Replace the display bezel (see
7. Replace the hinge caps (see
8. Replace the display assembly (see
9. Replace the memory module (see
10. Replace the battery (see Replacing the
11. Replace the palm-rest assembly (see
12. Replace the keyboard (see
13. Replace the label door (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Replacing the Display Panel).
Replacing the Display Hinges).
Replacing the Display Bezel).
Replacing the Hinge Caps).
Replacing the Display Assembly).
Replacing the Memory Module).
Battery).
Replacing the Palm-Rest
Replacing the Keyboard).
Replacing the Label Door).
Assembly).