Wireless Mini-Card(S); Removing The Mini-Card(S) - Dell Inspiron 1090 Service Manual

Back to Contents Page
Wireless Mini-Card(s)
Dell™ Inspiron™ 1090 Service Manual
Removing the Mini-Card(s)
Replacing the Mini-Card(s)
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer has one full Mini-Card slot and one half Mini-Card slot:
One full Mini-Card slot — supports Wireless Wide Area Network (WWAN).
l
One half Mini-Card slot — supports Wireless Local Area Network (WLAN) or Worldwide Interoperability for Microwave Access (WiMax).
l
NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
Removing the Mini-Card(s)
1. Follow the instructions in Before You
2. Remove the label door (see
3. Remove the keyboard (see
4. Remove the palm-rest assembly (see
5. Remove the battery (see Removing the
6. Disconnect the antenna cables from the Mini-Card(s).
7. Remove the screw that secures the Mini-Card(s) to the system board.
1 antenna cables (2) 2 Mini-Card
3 screw 4 system-board connector
8. Lift the Mini-Card(s) out of the system-board connector.
Begin.
Removing the Label Door).
Removing the Keyboard).
Removing the Palm-Rest
Battery).
Removing the
Assembly).
Battery) before working inside the