Display Assembly; Removing The Display Assembly - Dell Inspiron 1090 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1090 Service Manual
Display Assembly
Hinge Caps
Display Bezel
Display Hinges
Display Panel
Display Cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the label door (see
3. Remove the keyboard (see
4. Remove the palm-rest assembly (see
5. Remove the battery (see Removing the
6. Remove the memory module (see
7. Disconnect the antenna cables from the Mini-Card(s).
8. Disconnect the ambient light-sensor cable, touch-screen cable, display cable, and camera cable from their connectors on the system board.
9. Note the routing of the ambient light-sensor cable, touch-screen cable, display cable, and camera cable and remove these cables from the routing
guides.
10. Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.
Begin.
Removing the Label Door).
Removing the Keyboard).
Removing the Palm-Rest
Battery).
Removing the Memory Module).
Removing the
Assembly).
Battery) before working inside the