Display Cable; Replacing The Display Panel; Removing The Display Cable - Dell Inspiron 1090 Service Manual

1 screws (8) 2 display back cover

Replacing the Display Panel

1. Follow the instructions in Before You
2. Align the display back cover on the display panel and snap it into place.
3. Replace the eight screws that secure the display back cover to the display panel.
4. Replace the display-panel hinge brackets.
5. Align the holes on the display-panel hinge brackets with the guide posts on the display frame and place it in position.
6. Route the display cable through the routing guide.
7. Replace the six screws that secure the display panel to the display frame.
8. Replace the display hinges (see
9. Replace the display bezel (see
10. Replace the hinge caps (see
11. Replace the display assembly (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Cable

Removing the Display Cable

1. Follow the instructions in Before You
2. Remove the display assembly (see
3. Remove the hinge caps (see
4. Remove the display bezel (see
5. Remove the display hinges (see
6. Remove the display panel (see
7. Turn the display panel over.
8. Disconnect the touch-screen cable from the connector on the display panel.
CAUTION: The two display-panel hinges are part of the display cable and cannot be removed separately.
9. Push the display-panel hinges out to release the tabs on the hinges from the slots on the display panel.
10. Lift the display-panel hinges and pull the pull-tab to disconnect the display cable from the connector on the display panel.
Begin.
Replacing the Display Hinges).
Replacing the Display Bezel).
Replacing the Hinge Caps).
Replacing the Display Assembly).
Begin.
Removing the Display Assembly).
Removing the Hinge Caps).
Removing the Display Bezel).
Removing the Display Hinges).
Removing the Display Panel).