Removing The Display-Feed Flex Cable (12.1-Inch Display Panel) - Dell Latitude C500 Series Service Manual

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Manual
3. Reinstall the four M3 x 3-mm screws that secure the display panel to the support bracket.

Removing the Display-Feed Flex Cable (12.1-Inch Display Panel)

Display-Feed Flex Cable
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface
on the computer.
NOTICE: Read "Preparing to Work Inside the
procedure.
1. Remove the hard
2. Remove the display
3. Remove the display assembly
4. Remove the four M3 x 3-mm screws that secure the display panel to the support bracket (see
Assembly Bezel and
5. Lift the bottom of the display panel out of the display-assembly top cover.
6. Disconnect the bottom flex cable connector from the inverter connector by pulling straight up on the attached pull tab.
7. Remove the tape that covers the display panel connector.
8. Pull the top flex cable connector down and away to remove it from the display panel connector.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...600/C500%20C600%20Service%20Manual/remove.htm (18 of 36)6/21/2004 1:22:14 AM
drive.
assembly.
bezel.
Panel").
Computer" before performing the following
"12.1-Inch Display