Dell Latitude C500 Series Service Manual page 45

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Manual
NOTICE: Read "Preparing to Work Inside the
procedure.
1. Remove the hard
2. Remove the keyboard
3. Remove the display
4. Remove the palmrest
5. Remove the system
6. Remove the battery latch button from the bottom case assembly by squeezing the snap tabs.
Apply pressure to the latch and spring while unsnapping the snap tabs to prevent the latch assembly from coming loose
from the case. If the latch assembly does come loose from the case:
a. Reinsert the spring onto the slider on the latch, and reinstall the module latch into the holding features on the
inside of the case.
b. Ensure that the slider is inserted in its respective hole, that the side of the latch with the two bumps is facing
the back of the case, and that the surface with the wear ribs is facing the bottom of the case.
NOTE: The latch will not function properly if the slider is oriented
incorrectly.
7. Snap in the new latch button from the bottom of the base, making certain the snap tabs are fully engaged in the latch.
8. Ensure that the newly installed latch moves smoothly and freely when pushed and released.
9. Repeat steps 5 through 7 for the modular bay latch.
Back to Contents Page
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...600/C500%20C600%20Service%20Manual/remove.htm (36 of 36)6/21/2004 1:22:14 AM
drive.
assembly.
assembly.
assembly.
board.
Computer" before performing the following