Removing The Memory Modules; Replacing The Memory Modules - Dell Latitude C500 Series Service Manual

Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Manual

Removing the Memory Modules

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface
on the computer.
NOTICE: Read "Preparing to Work Inside the
procedure.
1. Remove the memory module
2. To release a memory module from its socket, spread apart the inner tabs of the memory module socket just far
enough for the memory module to disengage from the socket. The module should pop up slightly.
3. Lift the memory module out of its socket.

Replacing the Memory Modules

1. If you only have one memory module, install it in the socket labeled "JDIM1." Install a second memory module in the
socket labeled "JDIM2."
NOTE: Memory modules are keyed, or designed to fit into their sockets, in only one
direction.
NOTICE: The memory module must be inserted at a 45-degree angle to avoid damaging the
connector.
2. Align the memory module's edge connector with the slot in the center of the memory module socket. With the module
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...600/C500%20C600%20Service%20Manual/remove.htm (5 of 36)6/21/2004 1:22:14 AM
Computer" before performing the following
cover.