Replacing The Display Panel; Removing The Display Panel Cable - Dell XPS M1730 Service Manual

1
3
6 Disconnect the light lobes connector using the pull-tab.
7 Remove the display panel.

Replacing the Display Panel

1 Replace the light lobes connector.
2 Replace the eight screws that attach the display panel brackets to each side
of the display panel.
3 Align the display panel with the display back and replace the four screws.
4 Connect the LCD camera cable to the display panel.
5 Route the cables back through their routing channels.
6 Replace the display bezel (see "Replacing the Display Bezel" on page 41).

Removing the Display Panel Cable

1 Remove the display assembly (see "Removing the Display Assembly" on
page 37).
2 Remove the display bezel (see "Removing the Display Bezel" on page 40).
3 Remove the display panel (see "Removing the Display Panel" on page 41).
4 Turn over the display panel, placing it on a clean surface.
NOTICE:
To avoid damage to the computer when replacing the bottom flex cable,
gently support the bottom of the inverter board with one finger as you reseat the
bottom flex-cable connector. Do not bend the inverter board.
5 Gently pull the pull-tab from the bottom flex-cable connector to release
the cable from the inverter board.
6 Squeeze the flex-cable release levers at either side of the top flex-cable
connector, releasing the connector.
42
Display Assembly
camera cable connector 2
screws (12)
display panel
4 light lobes connector