Storage; Mounting Table Saw To Workbench - Bosch GTS1031 Operating Instructions Manual

MOUNTING THE TABLE SAW
If table saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur-
face such as a stand or workbench, using the four
mounting holes 6 (Fig. 16).
1. If mounting to a workbench, the base should be
bolted securely using 1/4" hex bolts (not included)
through mounting holes 6.
Hint: If workbench is 3/4" thick, bolts will have to
be at least 3-1/2" long - if workbench is 1-1/2"
thick, bolts should be at least 4-1/2" long.
2. Locate and mark where the saw is to be mounted,
relative to holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through work-
bench.
4. Place table saw on workbench aligning holes in
base with holes drilled in workbench.
5. Insert four (4) 1/4" dia. bolts through holes in base
and supporting surface; then secure with (4) 1/4"
flat washers and (4) 1/4" hex nuts.
4
RiP FENCE
STORAGE
-16-