Troubleshooting - Bosch GTS1031 Operating Instructions Manual

Troubleshooting
PROBLEM 1.
2.
3.
4.
REMEDY 1.
2.
3.
4.
PROBLEM 1.
2.
REMEDY 1.
2.
PROBLEM I.
2.
REMEDY
PROBLEM
REMEDY
Turnswitch "OFF"andalways remove plug from the power source beforetrouble shooting.
TROUBLE: SAWWiLLNOTSTART
Powercord is not pluggedin.
Fuse or circuit breakertripped.
Corddamaged.
Burnedout switch.
Plugsawin.
Replace fuse or resettrippedcircuit breaker.
Have cord replacedbyanAuthorizedBoschService Centeror ServiceStation.
Have switchreplacedbyan AuthorizedBoschServiceCenter o r ServiceStation.
TROUBLE: BLADEDOES NOTCOME UPTO SPEED
Extension cordtoo light or too long.
Lowhousevoltage.
Replace withadequatecord.
Contactyourelectriccompany.
TROUBLE: EXCESSIVE ViBRATiON
Failure to tightentilt lock handle.
Bladeout of balance.
3. Sawnot mountedsecurelyto standor workbench.
4. Arbor Nutnot tight.
1.See"GettingTo KnowYourTableSaw"section,(Page9- 19).
2. DiscardBladeandusedifferentblade.
3. Tightenall mountinghardware, S ee"Mountingthe TableSaw"section,(Page16).
4. See"Assembly"section,"ChangingTheBlade"(Page14-15).
TROUBLE: CUTBINDS,BURNS,STALLS MOTOR WHENRiPPiNG
1. Dull bladewith impropertooth set.
2. Warpedboard.
3. Ripfencenot parallelto blade.
4. Spreaderout of alignment..
1.Sharpenor replaceblade.
2. Makesureconcave or hollowside is facing"DOWN"feedslowly.
3. See"Operating Adjustments"section"AligningRip Fence" ( Page19).
4. See"Assembly"section,"AttachingBladeGuard"(Page12- 13).
TROUBLE: CUTNOTTRUE AT90° OR45° POSiTiONS
Alignmentscrewsnot adjustedproperly.
1.See"OperatingAdjustments" section,"Adjusting
BladeParallel t o Miter Gauge Slots" (Page18).
TROUBLE: TiLTLOCK HANDLE ELEVATION WHEEL HARDTOMOVE
1. Bladetilt lockhandlenot loosenedwhen makingtilt adjustment.
2. Sawdust on depth screwthreads.
1.See"GettingTo KnowYourTableSaw"section,"BladeTilt LockKnob"(9-10).
2. See"MaintainingYourTableSaw"section,"Lubrication"(Page35).
-36-