Installing And Removing The Battery Pack; To Remove Battery - Black & Decker LST220 Instruction Manual

3.Ifthebattery p ack does notcharge p roperly:
a.Check c urrent atreceptacle byplugging ina lamp orother
appliance
b.Check t oseeifreceptacle isconnected toalight s witch
which t urns power offwhen youturn outthelights.
c.Move charger andbattery p ack toa location where t he
surrounding airtemperature isapproximately 60°F - 80°F
(16 °- 27°C).
d.Ifcharging problems persist, take thetool, b attery p ack and
charger toyourlocal s ervice center.
4.The battery p ack should b erecharged when itfails toproduce
sufficient power onjobswhich w ere easily done previously. DO
NOT CONTINUE touseunder these conditions. Follow thecharging
procedure. Youmay also charge a partially used pack whenever
youdesire w ithnoadverse a ffect onthebattery p ack.
5.Foreign m aterials ofaconductive nature s uch as,butnotlimited
to,steel wool, aluminum f oil,oranybuildup o fmetallic particles
should b ekept a way from charger cavities. Always u nplug t he
charger from thepower supply w hen there isnobattery p ack inthe
cavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze orimmerse charger inwater oranyother l iquid.
z_WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
iNSTALLiNG AND REMOVING THE BATTERY PACK
z_WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
TO iNSTALL BATTERY PACK: A_,
Insert battery pack into tool until fully
seated and an audible click is heard
(figure 2).
TO REMOVE BATTERY
PACK: Depress the battery release
button in the back of the battery pack
pull battery pack out of tool.