Installing/Removing Battery Pack; Assembly - Black & Decker LPHT120B Instruction Manual

to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
INSTALLING / REMOVING BATTERY PACK
WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure 2).
TO REMOVE BATTERY PACK:
Depress the battery release button in
the back of the battery pack and pull
battery pack out of tool (figure 2).
Transporting the Pole Trimmer
Always remove the battery from the handle and cover the blade with
the blade sheath when transporting the Pole Trimmer. See page 6 for
additional information on transporting the battery.
2
Joining Trimmer Head Module to Handle Module
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective blade sheath is in place on the blade
before performing the following operations. Failure to do this
could result in serious personal injury.
Combining the handle module (A) to the trimmer head module (B)
creates a pole trimmer that is approximately 6 foot in length as shown
in figure 3.
3
To attach the handle module to the trimmer head module:
1. Align the groove on the outside of
the coupling end of the handle module
(A) with the tongue on the inside of
the coupling end of the trimmer head
module (B). See
figure 4. Push the two sections
completely together.
2. Slide the threaded sleeve (6) figure 5
on the trimmer head module down as
far as possible and rotate the sleeve
clockwise until it stops and completely
covers the orange threads as shown
in figure 6.
WARNING: Always check to make
sure that the sleeve is completely
threaded on and that the orange
threads are no longer visible. Not
threading the sleeve completely on
could result in the modules becoming disconnected creating a
hazardous condition. Periodically check the connections to insure
that no orange threads are visible.
8

ASSEMBLY

4
Groove
5
6