Installing / Removing Battery Pack; To Install Battery Pack - Black & Decker LHT2240 Instruction Manual

INSTALLING / REMOVING BATTERY PACK

WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.

TO INSTALL BATTERY PACK:

Insert battery pack into tool until fully seated and an audible click
is heard (figure 2). Make sure battery pack is fully seated and fully
latched into position.
TO REMOVE BATTERY PACK: Depress
the battery release button in the back of the
battery pack and pull battery pack out of tool.
STATE OF CHARGE INDICATOR
(FIGURE 2a)
The battery is equipped with a state of
charge indicator. This can be used to
display the current level of charge in the
battery during use and during charging.
It does not indicate tool functionality and
is subject to variation based on product
components, temperature and end-user
application.
CHECKING STATE OF CHARGE DURING
USE (FIGURE 2b):
• Press the state of charge indicator button
(B1).
• The four LED's (B2) will illuminate
indicating the percent of charge in
the battery. See chart in figure 2b.
• If LED light does not illuminate,
charge battery.
2
2a
2b
B1
B2
<18%
18% - 45%
45% - 72%
72% - 100%
8
ASSEMBLY INSTRUCTIONS
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):
- Phillips Screwdriver
ATTACHING GUARD AND BAIL HANDLE TO TRIMMER
WARNING:
Only use with
handle and guard properly
assembled to hedge trimmer. The
use of the hedge trimmer without the
proper guard or handle provided may
result in serious personal injury.
The trimmer is shipped with the guard
and bail handle attached to the trimmer
with a plastic zip tie.
To assemble to trimmer:
• Cut the plastic zip tie.
• Remove the six screws that are
partially run into the trimmer
housing (figure 3).
• Slide the guard onto the front of the
trimmer housing.
• Insert two of the six screws into the
openings on the side of the guard
and tighten securely as shown in
figure 4.
• Slide the bail handle onto the front
of the trimmer housing behind the
guard.
• Insert the remaining four screws
into the openings on the side of the
bail handle and tighten securely as
shown in figure 5.
3
4
5