Black & Decker LST220 Instruction Manual page 12

• Insert the3/4inch (19mm)
end ofthebulkline intothe
hole (t)inthespool
totheslot a sshown i n
figure16.
• Wind thecutting line onto thespool in
the direction ofthe arrow onthespool.
Make sure towind theline onneatly and
inlayers. Donot c risscross (figure 17).
• When t hewound c utting line reaches
therecesses (u), c uttheline. ( figure 16).
• Fitthespool onto thetool a sdescribed
in"REPLACING THE SPOOL".
THE RBRC
TM
SEAL
The RBRC
TM
(Rechargeabte Battery Recycling
Corporation) Seal on the LI-ION battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by Black & Decker.
RBRC
TM
in cooperation with Black & Decker and other battery
users, has established programs in the United States to facilitate the
collection of spent LI-ION batteries. Help protect our environment
and conserve natural resources by returning the spent LI-ION
battery to an authorized Black & Decker service center or to your
local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery. RBRC
TM
is a registered trademark of the Rechargeable Battery Recycling
Corporation.
z_WARNING"
To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
TOOL RUNS SLOWLY
• Remove battery from toot.
• Check that the spool housing can rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not protrude more than
approximately 5-3/8 inches (136mm) from the spool. If it does, cut
it off so that it just reaches the line trimming blade.
12