Removing A Memory Upgrade Module; Checking The Memory Capacity - Fujitsu LifeBook N6470 User Manual

T
HE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU SHOULD ROUTINELY REMOVE FROM YOUR
NOTEBOOK
SYSTEM MEMORY CAPACITY

Removing a Memory Upgrade Module

1
Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2
Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3
While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your LifeBook notebook. (Figure 33)
4
Store the memory upgrade module in a static
guarded sleeve.
5
Replace the cover by following steps 9 and 10 of
Installing a Memory Upgrade Module.
A
FTER INSTALLING YOUR ADDED MEMORY MODULE
IN ORDER FOR THE
"H
IBERNATION

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] > Control Panel (Classic View) > System. The amount of
memory is displayed next to "Memory (RAM):"
. O ,
NCE IT IS INSTALLED YOU SHOULD LEAVE IT IN PLACE UNLESS YOU WANT TO INCREASE
.
S - -D
AVE TO ISK MODE TO OPERATE PROPERLY ON YOUR
(S - -D ) F
AVE TO ISK EATURE
72 - Memory Upgrade Module
Figure 33. Removing a Memory Upgrade Module
,
YOU MUST RESET THE POWER PLAN PARAMETERS
" 51.
ON PAGE
L B . S
IFE OOK NOTEBOOK EE