Valet Take-Over - Avital 5103 Owner's Manual

To turn the rear defogger output ON:
1. Simultaneously press & release the
mote control.
2. The lights will flash 3 times.
3. The rear defogger output will once again activate when the vehicle is
remote started.
If the remote start is on, the lights turn off then flash 3-times before returning
to normal output. The defogger activates as programmed.
If the temperature is greater than 55° F when remote start is activated, the
rear defogger does not activate for that start.

➢ Valet take-over

The Valet Take-Over feature allows the vehicle to remain running after the key
has been removed from the ignition. This feature is useful for occasions when
you wish to exit and lock the vehicle for short periods of time, but would like to
leave the motor running and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
press and release the optional momentary switch, then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or a shut-down
input is received. (See the previous Remote Start section for a complete list
of shut-down inputs.)
Valet Take Over does not work if the brake pedal is pressed.
© 2009 Directed Electronics. All rights reserved.
+
�������
+ buttons on the re-
for 1 second - or
13