Table of Contents
Advertisement
Valet take-over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet Take-Over:
1.
Before turning off the engine, press and release
mitter (or press and release the optional momentary switch). Then
wait fve seconds.
2.
Turn the ignition key to the OFF position. (The engine will stay run-
ning.) The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
This feature will not work if the brake pedal is being pressed.
30
© 2011 Directed Electronics. All rights reserved.
on the trans-
Hide quick links:
Advertisement
Table of Contents
