Disarming Without A Transmitter; Silent Mode - Avital 5103 Owner's Manual

➢ Disarming without a transmitter

If your transmitter is lost or damaged, you can manually disarm your vehicle
security system. To disarm the system without a transmitter, you must have the
vehicle's ignition key and know where the Valet
check with your installer at the time of installation for both the location and the
preset response (1-5 presses) of the Valet
1 press.
To disarm the security system, turn the ignition to the ON position.
Press and release the Valet button the preset number of times (one to five times)
within 15 seconds. After five seconds, the sys tem will disarm. If the system does
not disarm, you may have waited too long; turn the ignition off and on, and
then try again.
Location of Valet Button_________________________________
Number of Presses_____________________________________
Important: The Valet button can be programmed to re-
spond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for your
individual unit

➢ Silent mode

To temporarily turn off the arm or disarm chirps, use Silent Mode™. Press
for less than one second before arming or disarming, and the confirmation
chirp(s) will be eliminated for that one op er a tion only. If you want the arm/
disarm chirps turned off permanently, your dealer can do this for you. The Warn
Away® response to lighter impacts is bypassed if the system is armed using
Silent Mode. This ensures that no chirps will be emitted by the siren in an area
you want chirp-free. The system is still fully capable of triggering. Only the Warn
Away® response is bypassed.
© 2009 Directed Electronics. All rights reserved.
switch is located. Be sure to
®
switch. The factory default setting is
®
DRW-35
9