Table of Contents
Advertisement
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Ignition Valet Mode:
Insert the ignition key into the ignition switch. Within 10 sec.,
turn the key 5 times successively into the
The parking lights will flash three times to indicate that the vehicle is now in Valet Mode.
The L.E.D. will come
The Transmitter will display the
To take the system o u t o f Ignition Valet Mode:
Insert the ignition key into the ignition switch. Within 10 sec.,
turn the key 5 times successively into the
The parking lights will flash twice to indicate that the vehicle is now out of Valet Mode.
The L.E.D. will go out.
The
icon will disappear from the Transmitter; the LED will turn off.
Note: With the Ignition Valet activated, the remote starter and alarm functions will be disabled.
Start Attempts Indicator (Valet Mode)
This reveals start attempts made while the vehicle was in Valet Mode. The parking lights will:
Come
, go
; then
ON
OUT
Flash twice.
"Home Valet
TM
" Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote but the
alarm functions will still be active.
To take the system i n t o Home Valet Mode:
Press the
or
LOCK
UNLOCK
Within 5 seconds, press the Lock and
The Transmitter will BEEP once and will display the
To take the system o u t o f Home Valet Mode:
Turn the ignition key to the
The Transmitter will BEEP once and the
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
Go
then
; then
ON
OFF
Flash twice, pause; then
Flash twice again.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
Getting i n t o Remote Valet Mode
• Hold the
and
UNLOCK
• The Parking Lights will flash 3 times.
The Transmitter will BEEP once and will display the
solid.
User Guide
IGNITION ON / RUN
solid.
ON
icon; the LED will remain on solid.
IGNITION ON / RUN
button.
button simultaneously.
START/STOP
position.
IGNITION ON (RUN)
icon will disappear.
buttons simultaneously for 3 seconds.
START/STOP
and
positions.
OFF
and
positions.
OFF
icon.
icon; the LED will remain on
P. 6
Advertisement
Table of Contents
