Table of Contents
Advertisement
You will hear one chirp if the Siren or Horn is so configured.
2.
The icon will light up on the LCD display of the remote control. The parking lights will flash
once and the L.E.D. will flash slowly to confirm that the doors have been locked and that the
Starter Kill feature (if installed) and the alarm are armed.
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in Idle Mode:
1.
With the engine running, press the
button on the remote control until the parking lights come on.
START/STOP
Remove the key and exit the vehicle. The engine will go on running.
Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode:
1.
With the engine already running, press the
parking lights come
ON
Remove the ignition key from the ignition switch. The engine will go on running.
Exit the vehicle and close the door.
Press the
button to lock the doors; the engine will shut down after
TRUNK
60 seconds of Turbo Mode.
Valet Mode with the Valet Switch
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press the valet button (the parking lights will flash 3 times and the
L.E.D. will come
solid).
ON
— The Transmitter will display the
To take the system o u t o f Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press and release the valet button (the parking lights will flash twice
and the L.E.D. will come
OUT
— The
icon will disappear from the Transmitter.
Note: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
P. 5
or
button (to unlock the doors) or the
LOCK
UNLOCK
button on the transmitter until the
LOCK
.
position.
IGNITION ON (RUN)
icon.
position.
IGNITION ON (RUN)
).
User Guide
Advertisement
Table of Contents
