Table of Contents
Advertisement
To leave the vehicle in Idle Mode:
1.
With the engine running, press the
button on the remote control until the parking lights come on.
START/STOP
2.
Remove the key and exit the vehicle. The engine will go on running.
3.
Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then it will shut down the engine.
Proceed as follows to set the system to Turbo Mode:
1.
With the engine already running, press the
parking lights come
2.
Remove the ignition key from the ignition switch. The engine will go on running.
3.
Exit the vehicle and close the door.
Press the
TRUNK
60 seconds of Turbo Mode.
Valet Mode Using the Valet Switch
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1.
Turn the ignition key to the
2.
Within 3 seconds, press the valet button (the L.E.D. will come
To take the system o u t o f Valet Mode:
1.
Turn the ignition key to the
2.
Within 3 seconds, press and release the valet button (the L.E.D. will come
Note: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 seconds, turn the key 5 times
successively into the
• The parking lights will flash three times to indicate that the vehicle is now in Valet Mode.
The L.E.D. will come
To take the system o u t o f Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 seconds, turn the key 5 times
successively into the
• The parking lights will flash twice to indicate that the vehicle is no more in Valet Mode.
The L.E.D. will go out.
Remote Valet Mode
This feature will allow you to remotely put your system into Valet Mode by using the transmitter
instead of the Valet button as above.
P. 4
or
LOCK
UNLOCK
LOCK
.
ON
button to lock the doors; the engine will shut down after
position.
IGNITION ON (RUN)
position.
IGNITION ON (RUN)
and
positions.
IGNITION ON / RUN
OFF
solid.
ON
and
positions.
IGNITION ON / RUN
OFF
button (to unlock the doors) or the
button on the transmitter until the
solid).
ON
).
OUT
User Guide AS-1820 FM
Advertisement
Table of Contents
