Sony XDS-PD1000 Operation Manual page 108

Item number Item name
158 PLAYBACK MODE FOR INTERNAL Set whether to play multiple clips when playing clips in internal storage.
159 PROXY GENERATOR
160 INTER-MEDIA OVERLAP SELECT
a) When maintenance menu item M 397 PORT CONFIGURATION is set to "VTR mode".
Item number Item name
208 PROTOCOL FOR REMOTE(9P)
Sub-item
1 #2 (PB)
2 #1 (REC)
212 VIDEO REMOTE CONTROL
SELECT
a) Not displayed when the unit is in 23.98P mode.
108
Setup Menu
Menu items in the 100s, relating to the control panels
Menu items in the 200s, relating to the remote control interface
a)
Settings
clip: Plays single clips (clip mode).
continuous [cont]: Plays multiple clips consecutively (continuous
playback mode).
Note
When maintenance menu item M397 PORT CONFIGURATION is set to
"VTR mode", the playback mode is set to "continuous" and this item is not
displayed.
Set whether to generate proxy audio/video data when copying clips
without proxy AV data or partial clips to internal storage, the Clip folder
on Professional Discs, or UDF-format SxS memory cards, or when
uploading (PUT) from a computer using an FTP connection.
disable [dis]: Do not generate proxy AV data.
enable [ena]: Generate proxy AV data.
Set the overlap duration between media when simultaneously recording
or copying to multiple media discs/memory cards.
off: No overlap.
30 sec [30 s]: 30 seconds overlap.
1 min [1 m]: 1 minute overlap.
Settings
Select the protocol used with a REMOTE (9P) connector, for each port.
Select the protocol used with the playback port.
VTR: Sony 9-pin VTR protocol
VDCP: VDCP protocol
Note
When maintenance menu item M397 PORT CONFIGURATION is set to
"VTR mode", the protocol is set to "VTR" and this sub item is not
displayed.
Select the protocol used with the recording port.
VTR: Sony 9-pin VTR protocol
VDCP: VDCP protocol
Note
When maintenance menu item M397 PORT CONFIGURATION is set to
"VTR mode", the protocol is set to "VTR" and this sub item is not
displayed.
Select the method used to control the internal digital video processor
and to make related settings.
menu: Use the setup menu to change settings.
remote (down converter) [dc]: Control the down-converter from an
HKDV-900 or another device connected to the VIDEO CONTROL
connector.
remote (up converter) [uc]: Control the up-converter from an HKDV-
900 or another device connected to the VIDEO CONTROL
connector.