Sony XDS-PD1000 Operation Manual page 107

Item number Item name
130 DISPLAY DIMMER CONTROL
131 AUDIO VOLUME
142 REPEAT MODE
143 INDEX PICTURE POSITION
151 GUI OPERATION
155 STREAM CHASE
156 MONITOR OUT SELECT
157 LOW REMAINING CAPACITY
ALARM
Menu items in the 100s, relating to the control panels
Settings
Set the brightness of the indication on the LCD.
10%, 25%, 50%, 75%, 100%
Select whether each of the CH-1/ALL CH, CH-2 to CH-4 adjustment
knobs on the control panel is effective to control the audio recording level
and playback level on each channel or the CH-1/ALL CH adjustment
knob alone functions as a master control to control the audio level on all
channels together.
each: Each of the CH-1/ALL CH, CH-2 to CH-4 adjustment knobs is
effective to control each channel.
all: The CH-1/ALL CH adjustment knob alone functions as a master
control.
When "all" is selected, the ALL CH indicator under the CH-1/ALL CH
adjustment knob lights up.
Set whether to set repeat playback mode.
off: Do not set repeat playback mode.
play: Set repeat playback mode.
When "play" is selected, the icon indicating repeat playback mode
appears in the basic operation screen if the playback port is selected.
Select the frame of the clip to use as the thumbnail image (index picture)
when recording.
0sec to 10sec: Can be set in the range from 0 seconds (first frame of the
clip) to 10 seconds, in units of 1 second.
Sets whether to disable switching to the clip list screens.
enable [ena]: Enabled
via stop [stop]: Disabled (executable from stop mode only)
This setting is enabled when the target media is DISC or MEMORY.
Specify whether perform chase output with FTP/CIFS during recording.
disable (disc style) [disc]: Do not perform chase output with FTP/CIFS
(perform output in the MXF format compatible with previous devices
supporting Professional Discs).
disable (memory style) [mem]: Do not perform chase output with FTP/
CIFS (perform output in the MXF format compatible with previous
devices supporting SxS memory cards).
enable (growing style) [ena]: Perform chase output with FTP/CIFS
(perform output in the MXF format unique for chase output).
This unit supports MXF V1.3 format.
MXF V1.3 format supports chase output by enabling data in the header
metadata area storing information on clip length, etc. to the footer
partition at the end of the MXF file as well as to the header partition. This
enables clips being recorded to be output via FTP/CIFS and handled on
the network.
Note
When using a nonlinear editor that is not a Sony product, please contact
the maker to confirm whether it is possible or not to receive clips output
by the chase output function using MXF V1.3 format.
HD-SDI MONITOR/OUTPUT2, SD-SDI MONITOR/OUTPUT2,
COMPOSITE OUTPUT MONI/2, and HDMI OUTPUT connectors:
Select the signal that is output to the LCD display.
current port [auto]: Outputs signal from the selected port.
REC port [EE]: Always outputs EE signal.
Set the internal storage recording capacity for which to display the low
remaining capacity alarm.
5%: Displays alarm when remaining recording capacity falls below 5%.
10%: Displays alarm when remaining recording capacity falls below 10%.
15%: Displays alarm when remaining recording capacity falls below 15%.
Notes
• Deleting clips so that the remaining capacity is higher than the set
value will cancel the alarm.
• 5%, 10%, and 15% are equivalent to about 24 minutes, 48 minutes, and
72 minutes, respectively, when calculated for XAVC AI422 recording.
107
Setup Menu