GE GSE23GSESS Use And Care Manual page 33

Problem
No water or ice cube
production
CUBED ICE was selected
but CRUSHED ICE
was dispensed
(on some models)
Refrigerator has odor
Moisture forms on
outside of refrigerator
Moisture collects inside
(in humid weather, air
carries moisture into
refrigerator when doors
are opened)
Interior light does
not work
Water on kitchen floor or
on bottom of freezer
Hot air from bottom
of refrigerator
Refrigerator never
shuts off but the
temperatures are OK
Refrigerator is beeping
Door not closing properly
Actual temperature not
equal to Set temperature
Possible Causes
valve is clogged.
Dispenser is LOCKED
CRUSHED ICE.
odor to refrigerator.
periods of high humidity.
long door openings.
Due to the highter humidity in the This is normal for the beverage center.
refrigerator, you may on accasion
experience fog or small amounts
of moisture in the refrigerator
compartment.
For LED lights
Normal air flow cooling
motor. In the refrigeration
process, it is normal that
heat be expelled in the
area under the refrigerator.
Some floor coverings
are sensitive and will
discolor at these normal
and safe temperatures.
compressor running during
door openings.
Door is open.
sticking or folding over.
What To Do
Call a plumber.
Replace filter cartridge or remove filter and install plug.
Press and hold the LOCK pad for 3 seconds.
A few cubes were left in the crusher from the previous
setting. This is normal.
Foods with strong odors should be tightly wrapped.
Keep an open box of baking soda in the refrigerator;
replace every three months.
See Care and cleaning.
Wipe surface dry.
This is normal for the beverage center.
loads and environmental conditions change.
with a per towel if desired.
Replace fuse or reset the breaker.
See Replacing the light bulbs.
Call Service.
Poke ice through with a wooden spoon.
This is normal. The refrigerator will cycle off after the
door remains closed for 2 hours.
Close door.
Apply paraffin wax to the face of the gasket.
Allow 24 hours for system to stabilize.
Allow 24 hours for system to stabilize.
Allow 24 hours for system to stabilize.
Allow 24 hours for system to stabilize.
GEAppliances.com
33