Table of Contents
Advertisement
Even if FCB data other than X'6F' (stop code) is received with WIF7 = 1,
WIF7 is ignored (treated a 0) and WIF6 to WIFl are treated as format
control data and stored in the FCB.
when stop code X'6F' is used.
The total number of bytes contained in the FCB data LlHlL2H2...LnHn
be even.
If it is odd and the stop code
At that time, the printer feeds forms determining that the H n byte not
received (data of channel 7 to 12) for the last line is '1'00'
total number of lines on a form (page) is n lines.
If n is 1, an error occurs because there must be 2 or more lines on a
If n is greater than 255 -- that is, more than 255 lines are specified for
a page -- an error occurs and data from the 256th line and after is lost
because the FCB holds only 255 lines.
maximum of a 255-line page, storing up to L
line 255, in the FCB.
continues FCB data loading until it receives this code.
FCB data must be loaded after character codes of a previous line are
received,
data is loaded into the FCB incorrectly if the printer has unprinted
character codes in the PDB before the FCB load start code.
Line 1 must be set to the print line of the printer before or immediately
after FCB data loading because the FCB address counter is reset to 1 after
data
is received (that is, the printer treats line 1 as the print line
FCB
after FCB data is loaded).
If the printer receives start codes other than X'6C',
feeds forms as though it had received a Skip or Space command.
Example of FCB data:
. Line spacing:
. Form length:
Figure 4.10 shows the channels specified for a forms feed format.
Table 4.4 lists the FCB data.
channel 12 in the printer.
4 - 14
The stop code is required because the printer
printed, and cleared because character codes are destroyed and
6
lines/inch
66 lines
However, WIF7 should be 0, except
The printer feeds forms for a
255'255'
It is assumed that the BOF is set to
follows, an error occurs.
and that the
which
corresponds
must
to
it
Advertisement
Table of Contents
