Table 6.2 Operation By The Rts And Cts Combination - Fujitsu M304X Series Oem Manual

Table
Signal
Signal name
Test Mode
(TM)
The combinations of the RTS and CTS signals listed in Table 6.2 are provided
for the printer.

Table 6.2 Operation by the RTS and CTS combination

ENABLE
Half-duplex
mode
DISABL
Full-duplex ENABLE
mode
6.1 RS-232-C interface
For the RTS and CTS setup, refer to *!rator's
The printer sers rhe RTS on CO), waifs
and transmits data to the host when the CTS is set to 0.
ends, the primer sets the RTS off (1).
The printer sets the RTS on (0) and
whether the CTS is 0 or 1.
The printer keeps the RTS
printer transmits data.
signal lines -
Functions
If the host detects that
the local loopback rest is executable, it sets
this signal on (0).
If the host turns this
the LL signal being an, the host
this signal off (1) until the LL signal is ser to
If this signal is not set to 0 within 2 set
1.
after the printer sets
terminates the local loopback
LL off (I).
Function
for
transmits
When transmission ends, the
Continued
the LL signal is on and
signal on in response to
does
not set
the LL on CO), the printer
Guide.
the CTS to be see to 0,
data to the host
printer sets
6 - 7
the