Table of Contents
Advertisement
(10) Half-line Feed command
The Half-line Feed command specifies half-line (l/Z)
command is valid if the line feed pitch is 6 lpi.
is 8 lpi, this command is ignored.
This command operates in the same way as the line feed (LF) function
except that the number of lines to be fed is not 1 but l/Z.
the line feed pitch is l/12 lpi.
(11) Repeat Character command
The Repeat Character command directs the printer to repeat the character
code which the printer received before this control sequence, as many
times as specified in the parameter.
Example:
Data
Printing
The parameter of this command can specify 1 to 136.
R 1B 5B 31 30 62 OD
R R R R R R R R R R R
feeding.
If the line feed pitch
CR code
R is reported 10 times.
This
As a result,
6 - 27
Advertisement
Table of Contents
