Figure 2.14 Methods Of Fastening Paper - Fujitsu M304X Series Oem Manual

2.5.3 Multiple-part forms
This printer utilizes up to 6-part forms.
6-part forms and is not included in the number of parts. Forms with
interleaved carbon
paper are available as multiple-part forms.
must meet the specifications in Subsections 2.5.1 and 2.5'.2.
the same length and width.
This section describes the fastening, misalignment, and thickness of
multiple-part forms and also how multiple-part forms cause feed defects.
(1) Fastening
Each part of multiple-part forms must be fastened together at one or both
pin feed hole areas by gluing or crimping.
interleaved carbon paper should be fastened on the right.
not be used on forms.
damaged and a feed error will occur.
For gluing, do the following:
. The shape of glued parts should be dots or stripes in the vertical
direction, as shown in Figure 2.14,
. Glue should be applied evenly and must not cause wrinkles or discolor
the paper.
. Do not apply glue to the perforations.
the glue must not ooze through perforations of the top and bottom
layers.
. Glue cannot be used if forms lose pliability.
For crimping, do the following:
. Layers must be firmly fastened and must not come :Loose.
. There should be no paper tailings or dust.
. Forms should maintain their shape so as not to cause jams.
. Crimps must not overlap horizontal perforations.
horizontal
. Crimps should not project through the bottom shee,t.
If layers of multiple-part forms are not properly f,astened,
likely to peel apart, causing feed defects.
paper, carbon-backed
multiple-parts
If they are used, the printer print section will be
Stripe
gluing

Figure 2.14 Methods of fastening paper

perforations, the forms will tear at t:he perforation.
Interleaved
forms, and forms using carbonless copy
Each part of multiple-part forms
Multiple-part
If stripe gluing is necessary,
Dotted
Crimps
gluing
carbon paper utilizes
They must be of
forms with
If crimps overlap
the layers are
2 - 15