Duct Cover Option (Vwh 10"H. Wall Hoods W/Standard Ventilator); Installation (Vwh 10"H. Wall Hoods W/Recirculating Kit) - Viking VBCV36381 Installation Instructions Manual

Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Duct Cover Option
(VWH 10"H. Wall Hoods w/Standard Ventilator)
Measure distance from ceiling to canopy.
Installation
(VWH 10"H. Wall Hoods w/Recirculating Kit)
Remove damper and discard with transition.
34
Slide the duct cover in place and fasten from inside
canopy using the sheet metal screws provided.
Turn recirculating unit upside down. Place vent hood
upside down on recirculating unit.
Attach with screws and lock washers provided.
To reduce the risk of fire, electric shock, or injury
to persons, observe the following:
• Use this unit only in the manner intended by the
• Before servicing or cleaning unit, switch power off
Remove electrical box cover.
Flip hood over. Insert 6" of electrical wiring through the
top of vent hood and secure. Refer to local codes.
35
Attach with screws.
W A R N I N G
manufacturer. If you have any questions, contact
the manufacturer.
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.
CAUTION: Secure vent hood. Make sure mounting
screws are secured into framing. Use additional
mounting screws and wall anchors, if necessary.