Table of Contents
Advertisement
6
CAUTION: Secure vent hood to wall using screws
provided. Use additional mounting screws and wall
provided make sure top mounting screws are secured
anchors, if necessary.
7
BARE OR GREEN
GREEN
BLACK
WHITE
BLACK
WHITE
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
9
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
40
CAUTION: If not using a duct cover, using screws
into soffit or cabinet frame. Use additional mounting
screws, if necessary.
8
1
2
Replace electrical box cover. Make connection to
breaker box.
10
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
11
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Duct Cover Option
(DCH 12"H. Classic Chimney Wall Hoods w/Standard Ventilator)
1
Measure distance from ceiling to canopy.
3
Place duct cover top inside duct cover base and lower until
desired height is found. Mark height. Use the retaining nuts
and bolts to fasten in place from the inside and remove tape.
41
2
Tape to avoid scratching.
4
Slide duct cover in place and fasten from inside canopy
using the sheet metal screws provided.
Advertisement
Table of Contents
