Table of Contents
Advertisement
3
Place duct cover top inside duct cover base and lower until
desired height is found. Mark height. Use the retaining nuts
and bolts to fasten in place from inside and remove tape.
Duct Cover Option
(DTWN Tall Traditional Wall Hoods)
1
Measure distance from ceiling to canopy.
Installation
(DTWS Slim Traditional)
1
Flip hood over. Remove electrical box cover.
46
4
Slide duct cover in place and fasten from inside canopy
using the sheet metal screws provided.
2
Slide duct cover in place and fasten from inside canopy
using the sheet metal screws provided.
W A R N I N G
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING
• Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.
• Before servicing or cleaning unit, switch power off
at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.
2
1
Insert 6" of electrical wiring through the top of vent hood
CAUTION: Using screws provided, secure vent hood to wall.
and secure using wiring restrain. Refer to local codes.
Make sure mounting screws are secured into frame. Use
additional mounting screws and wall anchors, if necessary.
CAUTION: If not using a duct cover, use screws
provided and make sure top mounting screws are
secured into soffit or cabinet frame. Use additional
mounting screws, if necessary.
5
1
2
Replace electrical box cover. Make connection to
breaker box.
47
3
4
BARE OR GREEN
GREEN
BLACK
WHITE
BLACK
WHITE
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
To install ventillation kit
refer to ventillation kit
installation instructions.
Advertisement
Table of Contents
