Table of Contents
Advertisement
Control Function Menu Window
When you install the supplied SRX Controller in your
computer, you can operate all of the features of the projector
in your computer window. This section explains the
functions of the parts for projecting an image on the screen.
For the windows used for the settings and adjustments, see
"Adjustments and Settings Using the SRX Controller" on
page 61.
1
1
2
2
6
6
7
a Menu bar
File menu
Selecting "Quit" from the File menu exits the SRX
Controller.
Save Log: This item is for service use. For details, consult
your Sony dealer.
Password menu
Used to reset the authentication passwords required for
displaying the SETTING window and the SERVICE
window. The Password menu can be displayed only when
an authorized administrator starts the SRX Controller on
the computer for controlling the projector.
For details on the SETTING window and the SERVICE
window, refer to the Installation Manual for Dealers.
Help menu
Shows the version information of the SRX Controller and
the serial number of the projector.
b SCREEN CONTROL window
For details, see "SCREEN CONTROL window" on page
48.
c Information window
3
3
4
4
5
Location: Shows the installation location of the projector
Name: Shows the name of the projector that was set in the
Operation Timer: Shows the total operating hours (H) of
indicator: The bar indicator and the value (%) indicate
Warning Info: Displays an error message if there is any
d POWER ON/STANDBY (?/1) buttons and
Click "ON" to turn on the projector when the MAIN and
LAMP indicators at the rear of the projector are lit in red.
Both indicators and the POWER indicator on a computer
turn green, and you can operate the projector with the SRX
controller on the computer.
To turn off the projector, click "STANDBY" then click
"OK" in the displayed confirmation window. The
projector enters standby mode, and the indicator flashes
green. Even in standby mode, the fans continue to run to
reduce internal heat. When the fans stop running, the
indicator lights in red.
e FUNCTION 1 to 7 radio buttons
Register the data set or adjusted in the Control Function
Menu windows to these buttons, and recall it later to
project an image with that setting.
The setting items that can be registered are as follows:
• "INPUT SELECT," "MASKING ADJUST" and "CUT
OFF" settings in the SCREEN CONTROL window
• "Input Source" and "Signal Adjust" settings in the
PICTURE CONTROL window
• "Color" settings in the COLOR/FRAME window
• "ELECTRIC V SHIFT FUNCTION," "SQUEEZE,"
"PROGRESSIVE DISPLAY MODE," "LAMP
POWER" settings, "LENS CONTROL" settings when
that was set in the SETTING window.
SETTING window.
the projector.
the proportion of elapsed usage time to the
recommended time between replacements.
warning information on the projector. The same
message is displayed in the STATUS MESSAGE
window at the rear side of the projector.
POWER indicator
Location and Function of Controls
47
Advertisement
Table of Contents
