Table of Contents
Advertisement
Adobe RGB: Select when projecting Adobe RGB
compatible computer signals.
CUSTOM: Select when projecting a signal using the
color gamut defined by the user. The default value is
the same as DCDM.
Color Temp (temperature): Selects the color
temperature from among "DCI W/P," "6500K,"
"9300K," "CUSTOM1," "CUSTOM2" and
"CUSTOM3." 6500K is preset in CUSTOM1 to 3
settings in the factory.
"6500K" is recommended for a normal high-
definition signal or RGB signal. Set this item to "DCI
W/P" to project a movie source.
Gamma: Selects a gamma correction curve. The smaller
the value, the brighter the image. "2.2" is
recommended to project a normal high-definition
signal or RGB signal.
Select "2.6" or "2.2," or set a value from 1.80 to 2.59
(except 2.20) in 0.01 steps according to the signal
input. This allows projection of an image with
optimum brightness.
To set the gamma value in 0.01 steps, set "Gamma" to
"1.8," and click the "CUSTOMIZE" button. Input the
values in the Input Gamma Data screen and press the
"OK" button.
When a signal is input from the connector
on the LKRI-005
When you set each item in "Color," the setting will be
written to the color space description area of the EDID
ROM.
The values to be written to the EDID ROM are shown
below.
Color Space settings
sRGB(709): Red (0.6400, 0.3300), Green (0.3000,
0.6000), Blue (0.1500, 0.0600)
Adobe RGB: Red (0.6400, 0.3300), Green (0.2100,
0.7100), Blue (0.1500, 0.0600)
DCDM, CIE XYZ, CUSTOM: Red (0.6800,
0.3200), Green (0.2650, 0.6900), Blue (0.1500,
0.0600)
Color Temp settings
6500K: White (0.3127, 0.3290)
9300K: White (0.2840, 0.2970)
DCI W/P: White (0.3140, 0.3510)
CUSTOM1 to CUSTOM3: White (0.3127, 0.3290)
(default values)
Gamma settings
2.6: 2.6
2.2: 2.2
64
COLOR/FRAME Window
CUSTOMIZE: Value set using CUSTOMIZE
Frame Adjust
Adjusts the horizontal size and the position of the picture.
Clicking
increases the setting value, and
decreases it.
Clicking the "RESET" button resets all the settings of
"Frame Adjust" to the factory-preset values.
Dot Phase: Adjusts the phase of the SXRD panels and the
input signal. Adjust the value to obtain the clearest
picture. The item does not function with this
projector.
H Size: Adjusts the horizontal size of the picture according
to the input signal. As the setting value increases, the
horizontal size of the picture becomes larger. The
item does not function with this projector.
H Shift: Adjusts the horizontal position of the picture. As
the setting value increases, the picture moves to the
right. As the value decreases, the picture moves to the
left.
V Shift: Adjusts the vertical position of the picture. As the
setting value increases, the picture moves up. As the
value decreases, the picture moves down.
Note
If the position of the picture is not adjusted correctly, noise
may appear in the blank portion of the screen. This is not a
malfunction of the projector. Adjust the picture position
correctly with "Frame Adjust."
Advertisement
Table of Contents
