Advertisement
Introduction
This manual describes installation and configuration of the Motorola Vanguard
100 PC Frame Relay Access Device (PC FRAD). This manual is intended for
persons who are installing and setting up the Motorola Vanguard 100 PC.
The Vanguard 100 PC provides all of the functionality of a Vanguard 100 Frame
Relay Access Device (FRAD), in a high-speed PC serial card that is installed in
your desktop PC.
Software Revision Level
The Vanguard 100 PC runs Release 4.50 or higher of Motorola 6500 Series
operating software.
Special Notices
The following notices emphasize certain information in the manual. Each serves a
special purpose and is displayed in the format shown:
IMPORTANT:
Caution provides you with information that, if not followed, can result in
damage to software, hardware, or data.
Warning is the most serious notice, indicating that you can be physically hurt.
How To Use This Manual
Use the following table to help you find information in this manual on a particular
task or subject.
This section...
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Appendix A
Appendix B
Important is used to emphasize any significant procedural information.
Describes
Audience definition, PC hardware and software
requirements, and an overview of Vangua rd 100 PC features.
Warnings and cautions, unpacking, DSU connection
information, COM port and interrupt settings, Vanguard 100
PC board settings, and placing the Vanguard in your PC.
Optional DIM and Daughtercard hardware installation and
configuration.
PC COM software configuration, accessing the Control Port
to manipulate the Vanguard 100 PC, and saving and
downloading configurations.
Sample applications and configurations.
Specifications, including power and environmental
requirements.
Details of the sample configurations given in Chapter 5.
About This Guide
Advertisement
