Advertisement
Æ
Default Node (DN)
Ø
PC Control (PC)
Test (T)
Data Out (DO)
Ð
Data In (DI)
š
Status (S)
Used to reset all configurable parameters to default
value.
To default the node, you must:
Step Action
1
Power up the PC with the Vanguard 100
PC installed and wait 1 minute for the node
to initialize.
2
Enable the Default Node switch.
3
Press the reset button and allow the
Vanguard 100 PC to reboot. Wait 1 minute
for the node to initialize.
4
Disable the Default Node switch. The Node
default is complete.
Enabled: Allows the PC to override the Vanguard
100 PC switches CP, DI, DN, and Reset button.
Disabled: Enables the CP, DI, DN switches and
Reset button.
Note: This mode requires additional software to
run on your PC, which is currently not available.
This switch should remain disabled.
Indicates status of test results.
Enabled: Diagnostic Test Failed
Disabled: Normal Condition Flashing: Test in
Progress
Enabled: Data Leaving Port = SPACE
Disabled: Data Leaving Port = MARK
LEDs indicate Port 1 or 2.
Enabled: Data Entering Port = SPACE
Disabled: Data Leaving Port = MARK
LEDs indicate Port 1 or 2.
Enabled: Software Running
Disabled: Software Not Starting or Running
(Hardware Fault)
Flashing: Vanguard 100 PC booting, or software
download in progress
Advertisement
