Advertisement
Port #2 on-board DIM is available to support V.11, V.24, V.35, or V.36
DIMs
Eliminates the RS232 cable by internally connecting Port #3 to your PC
COM port
Eliminates the need for an external Frame Relay device, power supply,
and configuratio n terminal
The Vanguard 100 PC appears to the PC and communications software as if it
were a 16550 high-speed COM card.
Intended Audience
This manual is intended for those who are installing and configuring the
Vanguard 100 PC. It assumes that you are familiar with installing cards in your
PC and have an understanding of communications software in general.
PC Hardware and Software Requirements
The following hardware and software must be available before you install your
Vanguard 100 PC:
An IBM or IBM Compatible PC (286, 386, 486, or Pentium) with an
unobstructed full card ISA or VESA slot
A commercial communications software package (i.e., ProComm)
A Frame Relay, X.25, or ISDN connection supplied by your service
provider
Features
The Motorola Vanguard 100 PC is a FLASH-based mono FRAD or duo FRAD
available with an optional integral DSU, ISDN U or S/T, or DIM Site
daughtercard. An optional second port can be used for Dial Backup or as another
user port.
Vanguard 100 PC Software
The Vanguard 100 PC has all the functionality of a Vanguard 100. All Vanguard
100 software images from Release 4.50 and higher will run on a Vanguard 100
PC.
Advertisement
