Dell PowerConnect W-Airwave Manual page 17

wlsxSequenceNumberAnomalySta

wlsxApFloodAttack

wlsxInvalidMacOUIAP

wlsxInvalidMacOUISta

wlsxStaRepeatWEPIVViolation

wlsxStaWeakWEPIVViolation

wlsxStaAssociatedToUnsecureAP

wlsxStaUnAssociatedFromUnsecureAP

wlsxAPImpersonation

wlsxDisconnectStationAttackAP

wlsxDisconnectStationAttackSta

Diagnostic Steps to Ensure IDS & Auth Traps Display in AWMS
Validate your Dell PowerConnect ArubaOS configuration by exiting the "configure terminal" mode
and issue the following command:
(Controller-Name) # show snmp trap-list
If any of the traps below don't show as enabled enter configure terminal mode and issue the
following command:
(Controller-Name) (config) # snmp-server trap enable <TRAPS FROM LIST ABOVE>
Note : See Appendix A for the full command that can be copied and pasted directly into the Dell PowerConnect W CLI.
(Controller-Name) (config) # write mem
Saving Configuration...
Saved Configuration
Ensure the source IP of the traps match the IP that AWMS utilizes to manage the controller.
Navigate to Device > Monitoring page to validate the IP address.
Figure 11 Verify IP Address on Device > Monitoring Page
Verify that there is a SNMPv2 community string that matches the SNMP Trap community string
on the controller.
(Controller-Name) # #show snmp community
SNMP COMMUNITIES
----------------
COMMUNITY ACCESS
--------- ------
public READ_ONLY
(Controller-Name) # #show snmp trap-host
VERSION
-------
V1, V2c